1 Lead LED Light Bar Wiring Harness Kit, Double Color/High Low Beam Motorcycle Wire Harness with 7/8″ 22mm Handlebar Switch ON-Off-ON 12V Relay for Dirt Pit Bike ATV 50cc 70cc 110cc 125cc

Worked great to run some dual bulb lights to the engine guards on my bike. A few things you’ll need if you’re using there’s, solder or weatherproof connectors, some electrical tape or shrink wrap. Was pretty pleased with how they worked, has an easy to access inline fuse. The leads going to the lights have connectors so you can mount and connect the lights to the leads while still being able to run the wiring to the rest of the harness. I appreciated the length of cable to the fuse/relay and the leads to the lights.What I wasn’t thrilled about was the length of wiring to the switch or the switch itself. Not sure why the length leading to the switch is the shortest, so I had to get a bit creative in my cable management. I also don’t like that the switch lead uses a not sealed molex type connector, which also made me doubly concerned that I was going to pull out the wires while running the cable. Another 8-12 inches of cable would’ve been great, and a DT connector even better. Just weird since the light leads have nice screw on connectors. Also the clamp is kinda small on the switch itself. I had to put it closer to my grips than I wanted to place it because closer to the forks my bars are too thick. If you have thicker bars this might not work well. I managed. I knocked a star off because of these 2 things, I got it to work but it might not work for every bike.Pro tip, tape the screw on ends of the connectors to the end of the leads. I learned the hard way and ended up having to pull out my wiring to rerun them because the screw on connectors got stuck somewhere